From stephen.wornom at inria.fr Thu Nov 10 17:04:57 2016 From: stephen.wornom at inria.fr (Stephen Wornom) Date: Thu, 10 Nov 2016 18:04:57 +0100 (CET) Subject: [metis-users] partitionning unstructured meshes into tube-like partitions In-Reply-To: <1375824055.22501196.1478796059031.JavaMail.zimbra@inria.fr> Message-ID: <1460087226.22514556.1478797497799.JavaMail.zimbra@inria.fr> My team uses metis; I use metis to partition meshes without any knowledge of how the metis works; as a conswquence I accept whatever partitions metis gives and that is the problem. What I would like is to partition an x,y,z mesh such that all the partitions are in the x-y plane. To be clear I would like all the partitions to include both zmin and zmax that a tube-like partition of length Zmax-Zmin. The question is how do I tell metis to do this, by default metis cuts across the z-coorinate. Hope my question is clear, Thanks in advance, Stephen -------------- next part -------------- An HTML attachment was scrubbed... URL: From joe at gilith.com Thu Nov 10 18:36:54 2016 From: joe at gilith.com (Joe Leslie-Hurd) Date: Thu, 10 Nov 2016 10:36:54 -0800 Subject: [metis-users] partitionning unstructured meshes into tube-like partitions In-Reply-To: <1460087226.22514556.1478797497799.JavaMail.zimbra@inria.fr> References: <1375824055.22501196.1478796059031.JavaMail.zimbra@inria.fr> <1460087226.22514556.1478797497799.JavaMail.zimbra@inria.fr> Message-ID: Hi Stephen, Unfortunately this email list is for users of the Metis theorem prover: http://www.gilith.com/research/metis/ not the Metis graph partitioning program: http://glaros.dtc.umn.edu/gkhome/metis/metis/overview I suggest you ask your question on their support forum: http://glaros.dtc.umn.edu/gkhome/forum Cheers, Joe On Thu, Nov 10, 2016 at 9:04 AM, Stephen Wornom wrote: > My team uses metis; I use metis to partition meshes without any knowledge of > how the metis works; as a conswquence I accept whatever partitions metis > gives and that is the problem. > > What I would like is to partition an x,y,z mesh such that all the partitions > are in the x-y plane. To be clear I would like all the partitions to include > both zmin and zmax that a tube-like partition of length Zmax-Zmin. > > The question is how do I tell metis to do this, by default metis cuts > across the z-coorinate. > Hope my question is clear, > Thanks in advance, > Stephen > > _______________________________________________ > metis-users mailing list > metis-users at gilith.com > http://www.gilith.com/mailman/listinfo/metis-users >