From stephen.wornom at inria.fr Fri May 19 12:34:42 2017 From: stephen.wornom at inria.fr (Stephen Wornom) Date: Fri, 19 May 2017 14:34:42 +0200 (CEST) Subject: [metis-users] mestis - partitioning in z-tubes In-Reply-To: <984016265.5017616.1495197044310.JavaMail.zimbra@inria.fr> Message-ID: <1162672702.5030291.1495197282227.JavaMail.zimbra@inria.fr> I would like to partition a mesh into z-tubes. Each z-tubes contains Zmin and Zmax. How do I do this using metis? Hope my question is clear. Stephen p.s. Another way to say this is I want to partition the mesh only in the x,y plane. -------------- next part -------------- An HTML attachment was scrubbed... URL: From joe at gilith.com Fri May 19 15:51:17 2017 From: joe at gilith.com (Joe Leslie-Hurd) Date: Fri, 19 May 2017 08:51:17 -0700 Subject: [metis-users] mestis - partitioning in z-tubes In-Reply-To: <1162672702.5030291.1495197282227.JavaMail.zimbra@inria.fr> References: <984016265.5017616.1495197044310.JavaMail.zimbra@inria.fr> <1162672702.5030291.1495197282227.JavaMail.zimbra@inria.fr> Message-ID: Hi Stephen, Unfortunately this email list is for users of the Metis theorem prover: http://www.gilith.com/research/metis/ not the Metis graph partitioning program: http://glaros.dtc.umn.edu/gkhome/metis/metis/overview I suggest you ask your question on their support forum: http://glaros.dtc.umn.edu/gkhome/forum Cheers, Joe On Fri, May 19, 2017 at 5:34 AM, Stephen Wornom wrote: > I would like to partition a mesh into z-tubes. > Each z-tubes contains Zmin and Zmax. > How do I do this using metis? > Hope my question is clear. > Stephen > p.s. > Another way to say this is I want to partition the mesh only in the x,y > plane. > > _______________________________________________ > metis-users mailing list > metis-users at gilith.com > http://www.gilith.com/mailman/listinfo/metis-users >